Hybrid II-O/III-N LED (ZnO-based LED)
Due to a direct bandgap of 3.37 eV and a high exciton binding energy of ~60 meV, ZnO has gained substantial interest as a promising material for highly efficient UV light-emitting diodes (LEDs) and laser diodes (LDs) based on exciton recombination. Availability of native ZnO substrates and wurtzite MgZnO and CdZnO alloys with a bandgap varying from ~2 eV to ~4 eV makes feasible growth of low-dislocation heterostructures necessary for LED and LD fabrication. However, lack of reliable and stable p-doping hinders development of ZnO-based light emitters. To overcome this problem, hybrid LEDs have been suggested, consisting of n-type II-oxide layers grown on p-type III-nitride materials. Most promising are LEDs providing carrier confinement in a narrow-bandgap active region sandwiched between wide-bandgap claddings. Hybrid II-O/III-N LEDs have some specific features of their operation originated from a type-II band alignment and a negative polarization charge at the II-O/III-N interface. The basic mechanisms of hybrid II-O/III-N light-emitting diode operation can be investigated by numerical simulations.
In this section, a hybrid LED double heterostructure is considered that consists of a 200 nm n-ZnO contact layer (n ~ 4×1018 cm-3), a 40 nm n-Mg0.1Zn0.9O stopper layer (n ~ 1017 cm-3), a 40 nm p-Al0.16Ga0.84N stopper layer (p ~ 1017 cm-3), a 0.5 μm p-GaN contact layer (p ~ 1017 cm-3), and an undoped 10 nm Cd0.07Zn0.93O quantum well (QW) sandwiched between the p-AlGaN and n-MgZnO stopper layers.
The QW is used to increase the concentration of the injected carrier and thus to improve IQE of the heterostructure. The operation of the DHS LEDs is simulated, assuming the Ga(Zn)-polarity of the crystal and threading dislocation density of 2×108 cm-2 in the whole structure. Some computation results are demonstrated in Figs.1-6.
In Fig.1 are shown computed band diagrams and carrier concentrations of the DHS LEDs at j = 50 A/cm2. The built-in polarization charges induce strong carrier localization next to the active layer interfaces (Fig.2). Nevertheless, the bulk of the active region is found to provide a major contribution to the emission spectra due to a higher concentration of non-equilibrium carriers (Fig.3). Similar results are also predicted for elevated operation temperatures in figures 4 and 5.
The internal quantum efficiency (IQE) as a function of temperature for different values of the current density is plotted in Fig.6.
The structure with CdZnO QW provides theoretically IQE of ~80-85% both at a low (50 A/cm2) and a high (400 A/cm2) current density. This value is comparable with the theoretically predicted IQE of conventional blue III-nitride LEDs.
It should be noted, that hybrid II-O/III-N DHS LEDs provide a high IQE even at elevated operation temperatures.
You can find more detailes in the paper by K.A. Bulashevich, I.Yu. Evstratov, S.Yu. Karpov “Hybrid ZnO/III-nitride light-emitting diodes: modelling analysis of operation” phys. stat. solidi (a) 204, 241-245 (2007)